Insulation Company in North Hollywood, CA
Blown in insulation is the most common call we get from North Hollywood homeowners, and the reason comes down to how this part of the Valley was built. Most of the housing stock went up between the 1940s and 1960s, when cheap energy made insulation an afterthought. Those original attics now carry either a thin layer of settled mineral wool or nothing at all. Meanwhile, summer attic temperatures in North Hollywood routinely hit 140 to 160°F. The result is a house that bakes from the top down, pushing your AC to run constantly. We only do insulation, which means we do it better. Call us at (877) 680-3557 for a free estimate on blown in insulation in North Hollywood.
Why North Hollywood Homes Are Different
North Hollywood’s housing stock was built for a climate that barely needs heating. The single-story stucco tract houses that dominate the neighborhoods east of Lankershim and north of Burbank Boulevard date mostly from the post-war years, when builders framed attics with minimal venting and skipped insulation entirely or dropped in a thin layer that has long since compacted. Stucco exteriors absorb the Valley sun all afternoon, and low-pitch or flat roofs leave very little attic air space for heat to escape. That combination means attic temperatures climb far above the outside air, and that heat radiates through ceilings into living spaces for hours after sunset. In the older stucco tracts around 91601 and 91606, we regularly find original attics with no baffles, no vent chutes, and wiring from the knob-and-tube or early Romex era that requires careful workmanship around junction boxes when blowing in new material. This is heat-defense work, not cold-weather insulation, and the approach has to match that from the first estimate.
Our Main North Hollywood Services
Two services account for most of what North Hollywood homeowners ask us about: attic insulation and spray foam. Each one addresses the same core problem – intense summer heat soaking through the ceiling – but they do it with different materials and different installation methods.
Attic Insulation in North Hollywood
Attic insulation is the highest-ROI upgrade for most North Hollywood homes because the attic is where the heat enters first. In the older stucco tracts around 91611 and 91612, we see attics with a thin layer of settled mineral wool that tests at R-8 or less, far below what the Valley climate demands. Adding the right material – batts, blown-in, or spray foam depending on the attic’s layout and venting – can drop upstairs temperatures by ten degrees or more in August. Flat and low-pitch roofs complicate the work because there is little space to maneuver, so we scope every job before quoting. Read the full breakdown at Attic Insulation in North Hollywood.
Spray Foam Insulation in North Hollywood
Spray foam earns its keep in North Hollywood on homes with flat roofs, enclosed rafter bays, and other spaces where traditional batts or blown-in material underperform. Closed-cell foam, which we install from the Demilec line, adds both thermal resistance and structural rigidity, making it a strong fit for the low-pitch roofs common across 91615 and 91616. Open-cell foam works well in vented attics where air sealing is the bigger priority. Spray foam is not a one-material answer for every home, and we will tell you when blown-in or batts make more sense for your budget. See Spray Foam Insulation in North Hollywood for the specifics.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Blown In Insulation in North Hollywood
Blown in insulation in North Hollywood is the workhorse fix for older attics, and it usually solves the exact problem these homes have: a wide attic floor with thin or missing coverage that lets 140°F attic air drive heat into the rooms below. Because so many of the original tract houses in 91611 and 91612 have low-pitch roofs, there is not much vertical attic space, and that means the blown-in job needs baffles and vent chutes installed before any material goes down. We install both fiberglass and cellulose blown-in material, and the right choice depends on your attic’s depth, your budget, and whether you want the recycled-content option that Blown In Insulation customers often ask about. The typical North Hollywood job takes one day, and most homeowners feel the difference the same afternoon.
Blown In Attic Insulation
Signs you need it
You need blown in attic insulation in North Hollywood if rooms feel hotter than the thermostat says, your AC runs long cycles in the afternoon, or you can see the tops of your ceiling joists because the existing layer has settled to nearly nothing.
What it costs in North Hollywood
Blown in attic insulation in North Hollywood typically runs $1.50 to $3.50 per square foot depending on the target R-value and whether old material has to be removed first.
How we do it
We seal bypasses around plumbing vents and wiring penetrations, install baffles and vent chutes to keep the soffit vents open, blow the material to the specified depth, and verify the coverage with a depth check before we pack up.
Blown In Cellulose Insulation
Signs you need it
Homeowners in North Hollywood choose blown in cellulose when they want a recycled-content material that slows air movement through the attic better than lighter fiberglass, especially in older homes with uneven joist spacing.
What it costs in North Hollywood
Blown in cellulose insulation in North Hollywood typically falls in the $1.75 to $3.00 per square foot range, with most whole-attic jobs landing between $1,800 and $3,500.
How we do it
We use the GreenFiber cellulose line, blowing it to the density that gives you the R-value we agreed on, and we hit the attic boundaries carefully so the material stays where it belongs instead of drifting into vents.
Blown In Fiberglass Insulation
Signs you need it
Fiberglass blown in insulation makes sense in North Hollywood when you want a lighter material that goes in faster and costs less upfront, particularly for large open attics over single-story stucco homes.
What it costs in North Hollywood
Blown in fiberglass in North Hollywood typically runs $1.50 to $3.50 per square foot, with a standard 1,200-square-foot attic landing between $1,800 and $4,200 depending on depth.
How we do it
We run the hose from the truck, blow the fiberglass in a controlled pattern, and level it so the R-value is consistent across the whole attic floor instead of thick in some spots and bare in others.
What Blown In Insulation Costs in North Hollywood
| Item | Typical range in North Hollywood |
|---|---|
| Blown in attic insulation (whole attic) | $1,800 – $3,500 |
| Blown in cellulose (per sq ft) | $1.75 – $3.00 |
| Blown in fiberglass (per sq ft) | $1.50 – $3.50 |
Is blown in insulation worth it in a North Hollywood summer?
Yes. In North Hollywood, blown in insulation is one of the highest-ROI comfort upgrades because attic heat drives most of a home’s cooling load. Most customers notice cooler rooms within a day of installation. Call (877) 680-3557 for a specific number for your attic.
Can you blow insulation over the old material in my North Hollywood attic?
Usually yes, as long as the old material is dry and free of rodent droppings or fire hazards like exposed knob-and-tube wiring. We check first and tell you honestly whether removal is needed before adding new blown in insulation. Call (877) 680-3557 to schedule an attic assessment.
Brands We Service in North Hollywood
We install blown in insulation from Demilec, GreenFiber, Owens Corning, and Johns Manville, and we keep all four material lines stocked for North Hollywood jobs. That means no week-long waits for a specific product. Learn more about the full lineup on our brands page.
Pricing for Insulation Company in North Hollywood, CA
| Service | Typical range in North Hollywood |
|---|---|
| Blown in attic insulation (whole attic) | $1,800 – $3,500 |
| Blown in cellulose (per sq ft) | $1.75 – $3.00 |
| Blown in fiberglass (per sq ft) | $1.50 – $3.50 |
| Attic insulation (whole attic) | $1,500 – $2,600 |
| Spray foam insulation (per sq ft) | $4.00 – $7.00 |
The biggest swing factor in North Hollywood pricing is attic access. Homes with flat or very low-pitch roofs leave less working room, which adds time to any blown in or batts job. We quote a fixed price after the attic inspection, so the number we give you is the number on the invoice.
Neighborhoods We Serve in North Hollywood
We cover all of North Hollywood, from the older tracts east of Vineland to the townhome pockets west of the 170 and the streets around the NoHo Arts District. Our typical response time for estimates in the Valley is one to two business days.
- North Hollywood proper (91601 and 91606)
- Valley Village
- NoHo Arts District
- Toluca Lake
- West North Hollywood (91607)
Service Area – Cities Near North Hollywood
We serve the surrounding San Fernando Valley communities with the same insulation-only focus. Homeowners in Studio City, CA, Universal City, CA, Burbank, CA, and Valley Glen, CA call us for blown in, attic, and spray foam work, and we run crews across the Valley every week.
Serving North Hollywood, CA — Our Local Coverage Area
We’re based in the North Hollywood area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Insulation Company in North Hollywood
Most North Hollywood estimates happen within one to two business days of your call. We schedule around the crew’s existing Valley routes, so mornings and midday slots fill fastest. Call (877) 680-3557 and we will get you on the board.
For single-family homes, no. For attached townhomes or condos, the HOA sometimes needs notice before work in shared attics or common walls. We can scope the job first and tell you exactly what the HOA will ask to see. Call (877) 680-3557 to talk through your building’s rules.
Do you work on older North Hollywood homes with knob-and-tube wiring?
Yes, but carefully. Homes built before roughly 1950 often still have knob-and-tube or early Romex in the attic, and we will not bury live wiring under insulation. We flag it during the inspection and work with you or your electrician to make the job safe before we blow anything in. Call (877) 680-3557 for an attic assessment.
What happens when you call
- 1A real person answersNo phone trees — talk to a local insulation pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3A background-checked tech heads outLicensed & insured, typically within the hour.
- 4You approve before work beginsNothing starts until you say go.
What North Hollywood Customers Say
"Found and sealed a gap around the chimney chase that was basically an open chimney to the attic."
— Beatriz Vargas"Told me the crawlspace didn't need doing and only the attic did. Half the job, half the money."
— Miguel Flores"He did a blower door test before and after and gave me the numbers. I like being able to see the difference rather than being told about it."
— Nia Robinson