Insulation Company in Burbank, CA
Blown in insulation is the most common fix we install in Burbank, and for good reason: most homes here were built between 1920 and 1955 with attics that were never properly insulated, or were blown over once decades ago at a fraction of today’s recommended R-value. The hot San Fernando Valley sun turns those under-insulated attics into ovens, pushing heat down into living spaces and driving cooling bills up from June through October. We’re Orange County Insulation, an insulation-only contractor, and we’ve served Burbank since 2013. Call us at (877) 680-3557 for a free estimate on any insulation job.
If you need attic or spray foam work specifically, those services have dedicated Burbank pages linked below. This page covers the full picture of insulation in Burbank, with blown in insulation as the primary focus.
Why Burbank Homes Are Different
Burbank’s housing stock creates insulation challenges you won’t find in a newer master-planned community. The dominant home types are 1920s through 1950s California bungalows and small Spanish and Colonial Revival houses on raised foundations. Many of these still have their original wood-sash windows, and a surprising number have attics where insulation was either never installed or blown in so long ago it’s settled to R-11 or worse. We also see mid-century tracts and postwar apartment blocks throughout the city, along with flat-roofed commercial and apartment buildings near downtown that have no attic cavity at all.
The climate compounds the problem. Burbank sits in the hot, dry San Fernando Valley basin, where summer highs routinely pass 100°F. Attic temperatures climb far higher than the outdoor air, and the Verdugo Mountains foothills along the northeast side of the city add wind-driven heat to hillside homes with west- and south-facing exposures. And there’s the aircraft noise. Burbank lies directly under the flight paths of Hollywood Burbank Airport, and neighborhoods from Magnolia Park up through the Rancho and Hillside areas hear low overflight noise daily. That means many Burbank homeowners want insulation that handles both heat and sound, which changes the material conversation entirely.
Our Main Burbank Services
Two services dominate the calls we get from Burbank homeowners: attic insulation and spray foam. Here’s what each involves in this city.
Attic Insulation in Burbank
Most Burbank attics we inspect fall into one of two categories: never insulated, or insulated decades ago with a thin layer that’s settled and performing poorly. The attic is the single biggest heat-gain zone in a Burbank home, and upgrading it is usually the highest-impact insulation job we can do. We match the material to the attic’s access, framing, and existing conditions rather than defaulting to whatever’s easiest to blow in. For full details on Attic Insulation in Burbank, see the dedicated page.
Spray Foam Insulation in Burbank
Spray foam matters in Burbank for two reasons specific to this city: flat-roofed mid-century buildings near downtown that have no attic to blow into, and hillside homes where air sealing matters as much as R-value. Closed-cell foam also adds structural rigidity, which helps on older raised-foundation bungalows. We install both open-cell and closed-cell systems. For a deeper look at Spray Foam Insulation in Burbank, including where foam makes sense and where it doesn’t, see that page.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Blown In Insulation in Burbank
Blown in insulation is the workhorse solution for Burbank’s older bungalows and postwar tract homes, where attic access is tight and existing insulation is thin or settled. Loose fill material gets into every corner and cavity of an attic, reaching around framing and obstructions that batts can’t cover cleanly. We install cellulose and fiberglass blown in systems depending on the home’s conditions, budget, and sound-control needs. Most Burbank jobs are completed in half a day to a full day. Our team installs Blown In Insulation with the same quality standard we bring to every project, and we carry products from Owens Corning and Johns Manville plus GreenFiber cellulose.
Cellulose Insulation
Signs you need it
Your attic insulation is settled more than an inch below the top of the joists, or you can see bare ceiling drywall between joist bays.
What it costs in Burbank
Blown in cellulose in a Burbank attic typically runs $1,150 to $2,600 depending on square footage and depth, with labor and material bundled into that range.
How we do it
We air-seal top plates and penetrations, then blow GreenFiber cellulose to the specified R-value using a calibrated machine, checking depth markers as we go.
Blown In Fiberglass Insulation
Signs you need it
Your existing fiberglass batts are compressed, damp, or torn, and you want a full-cover loose fill solution instead of patching.
What it costs in Burbank
Blown in fiberglass in Burbank typically costs $900 to $2,200 for a standard attic, depending on depth and access.
How we do it
We remove or work over damaged batts as needed, then blow fiberglass loose fill to a consistent depth with a blowing machine calibrated per manufacturer specs.
Blown In Cellulose Insulation
Signs you need it
You want a recycled-content option with better sound-blocking performance than fiberglass, particularly if aircraft noise from Hollywood Burbank Airport is a complaint.
What it costs in Burbank
Dense-packed or standard blown in cellulose in Burbank runs $1,200 to $2,800 for most attics, with higher-end jobs on larger footprints.
How we do it
We blow GreenFiber cellulose to the target R-value, dense-packing cavity areas where sound insulation is the priority rather than just thermal performance.
Loose Fill Insulation
Signs you need it
Your attic has low spots, odd framing, or shallow joist cavities where batts leave gaps and don’t sit flush.
What it costs in Burbank
Loose fill attic work in Burbank generally lands between $1,000 and $2,500, with the final figure driven by depth, square footage, and access.
How we do it
We lay down depth markers, run the loose fill through a blower, and level it across the full attic floor so the R-value is consistent wall to wall.
What Blown In Insulation Costs in Burbank
| Item | Typical range in Burbank |
|---|---|
| Basic blown in attic insulation (fiberglass) | $900 – $2,200 |
| Blown in cellulose attic insulation | $1,150 – $2,600 |
| Dense-pack cellulose for sound control (airport noise) | $1,200 – $2,800 |
These figures reflect what we see across Burbank’s 91505, 91506, 91507, and 91508 ZIP codes. Attic access, existing insulation removal, and square footage move the number.
Is blown in insulation worth it for a Burbank attic?
Yes, especially in Burbank’s pre-1960 homes where attic insulation is often decades old or missing entirely. It cuts heat gain from the Valley sun, lowers cooling costs, and can reduce aircraft noise. Call (877) 680-3557 for a free estimate.
How long does blown in insulation last in Burbank’s climate?
Cellulose and fiberglass both last 20 to 30 years in Burbank’s dry conditions, with cellulose holding its R-value slightly better as it settles. If yours is over 20 years old, it’s worth an inspection.
Brands We Service in Burbank
We stock and install insulation from Owens Corning, Johns Manville, Knauf, and Rockwool, along with several other manufacturer brands. Because we’re an insulation-only contractor, we choose the right material for the house rather than pushing whatever one supplier happens to carry. See our brands for the full roster.
Pricing for Insulation Company in Burbank, CA
| Service | Typical range in Burbank |
|---|---|
| Blown in fiberglass attic insulation | $900 – $2,200 |
| Blown in cellulose attic insulation | $1,150 – $2,600 |
| Dense-pack cellulose for sound control | $1,200 – $2,800 |
| Loose fill attic insulation | $1,000 – $2,500 |
| Air sealing + blown in attic insulation package | $1,500 – $3,400 |
Burbank prices push higher when attics are tight or have old knob-and-tube wiring that needs to be worked around, when the existing insulation has to be removed first, or when sound control is the primary goal and we’re dense-packing walls rather than just blowing the attic floor. Every quote is upfront and line-itemed, and estimates are free.
Neighborhoods We Serve in Burbank
We work across the entire city of Burbank, from the flatland bungalow streets to the hillside corridors. Our crews know the older homes in the Chandler Bike Path corridor, the mid-century tracts, and the ranch-style properties throughout the city. Typical response time for a Burbank estimate is within a few business days.
- Magnolia Park
- The Rancho
- Hillside District
- McNeil
- Northwest District
Service Area – Cities Near Burbank
Orange County Insulation also serves the surrounding communities in the San Fernando Valley and adjacent areas. If you’re in Universal City, CA, right over the hill from Burbank, we cover that territory. We also work in North Hollywood, CA to the west, Glendale, CA to the east, and Studio City, CA just south over the Cahuenga Pass. Call (877) 680-3557 to confirm coverage for your address.
Serving Burbank, CA — Our Local Coverage Area
We’re based in the Burbank area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Insulation Company in Burbank
Most insulation upgrades don’t require a city permit in Burbank, but some spray foam or structural situations may need one. We’ll tell you before work starts if a permit is needed and can handle the process. Call (877) 680-3557 to discuss your specific house.
We schedule free estimates throughout Burbank weekly, and most homeowners get an appointment within a few business days. Emergency jobs, like insulation being removed after a leak, get prioritized. Call (877) 680-3557 to get on the schedule.
Yes. We’ve worked with Burbank condo buildings and HOA-managed properties, particularly on shared attic spaces and sound insulation between units. We can provide the documentation your association needs. Call (877) 680-3557 for details.
If you’re ready to fix your Burbank home’s insulation, call Orange County Insulation at (877) 680-3557 for a free, no-pressure estimate. We only do insulation, which means we do it better.
What happens when you call
- 1A real person answersNo phone trees — talk to a local insulation pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3A background-checked tech heads outLicensed & insured, typically within the hour.
- 4You approve before work beginsNothing starts until you say go.
What Burbank Customers Say
"Found and sealed a gap around the chimney chase that was basically an open chimney to the attic."
— Beatriz Vargas"Told me the crawlspace didn't need doing and only the attic did. Half the job, half the money."
— Miguel Flores"He did a blower door test before and after and gave me the numbers. I like being able to see the difference rather than being told about it."
— Nia Robinson